Airworthiness Directive 2009-07-11
recurringAirworthiness Directives; Boeing Model 737-300, -400, and -500 Series Airplanes
What this AD requires
The FAA is superseding an existing airworthiness directive (AD), which applies to all Boeing Model 737-300, -400, and -500 series airplanes. That AD currently requires repetitive inspections for discrepancies of the fuselage skin under the dorsal fin assembly, and repairing if necessary. This new AD requires an inspection for any chafing or crack in the fuselage skin and abrasion resistant coating at the dorsal fin landing, an inspection for damage to the dorsal fin seals, attach clip, and seal retainer, and other specified and corrective actions as necessary. The new requirements will end the need for the existing repetitive inspections. This AD results from a report of an 18-inch crack found in the fuselage skin area under the blade seals of the nose cap of the dorsal fin due to previous wear damage, and additional reports of fuselage skin wear. We are issuing this AD to prevent discrepancies of the fuselage skin, which could result in fatigue cracking due to cabin pressurization and consequent rapid in- flight decompression of the airplane fuselage.
Which aircraft AD 2009-07-11 applies to
Whether AD 2009-07-11 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.