Airworthiness Directive 2009-20-09
recurringAirworthiness Directives; Boeing Model 767-200, -300, and -300F Series Airplanes
What this AD requires
We are adopting a new airworthiness directive (AD) for certain Boeing Model 767-200, -300, and -300F series airplanes. This AD requires repetitive inspections for fatigue cracking and corrosion of the upper link fuse pin of the nacelle struts, and related investigative and corrective actions if necessary. This AD also provides terminating action for the repetitive inspections. This AD results from two reports of cracked upper link fuse pins. We are issuing this AD to prevent fatigue cracking or corrosion of the upper link fuse pin, which could result in failure of the fuse pin and consequent reduced structural integrity of the nacelle strut and possible separation of the strut and engine from the airplane during flight.
Which aircraft AD 2009-20-09 applies to
Applies to airplanes identified in Boeing Alert Service Bulletin 767-54A0074, Revision 1, dated April 24, 2008.
Whether AD 2009-20-09 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.