Is AD 2008-13-12 a recurring Airworthiness Directive?

Yes — AD 2008-13-12 requires a repetitive inspection. Next-due depends on the aircraft's time in service.

Which aircraft does AD 2008-13-12 apply to?

AD 2008-13-12 applies to Boeing — models 737-100, 737-200, 737-200C, 737-300, 737-400, 737-500, 737. Serial/part conditions may narrow it to specific aircraft.

Airworthiness Directive 2008-13-12

recurring

Official AD 2008-13-12 · FR doc E8-25893 · 2008-11-14 · airframe

Airworthiness Directives; Boeing Model 737-100, -200, -200C, -300, -400, and -500 Series Airplanes

What this AD requires

The FAA is revising an existing airworthiness directive (AD) that applies to certain Boeing Model 737-100, -200, -200C, -300, -400, and -500 series airplanes. That AD currently requires various repetitive inspections for cracking of the upper frame to side frame splice of the fuselage, and other specified and corrective actions if necessary. That AD also provides for an optional preventive modification, which terminates the repetitive inspections. This new AD adds an optional terminating action that was inadvertently omitted from that AD. This AD results from a report that the upper frame of the fuselage was severed between stringers S-13L and S-14L at station 747, and the adjacent frame at station 767 had a 1.3-inch-long crack at the same stringer location. We are issuing this AD to detect and correct fatigue cracking of the upper frame to side frame splice of the fuselage, which could result in reduced structural integrity of the frame and adjacent lap joint. This reduced structural integrity can increase loading in the fuselage skin, which will accelerate skin crack growth and result in decompression of the airplane.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 2008-13-12 applies to

MakesBoeing

Models737-100, 737-200, 737-200C, 737-300, 737-400, 737-500, 737

As identified in Boeing Alert Service Bulletin 737-53A1261, dated January 19, 2006.

Whether AD 2008-13-12 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.

Date — When the work was done.

Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.

Signature & certificate — The A&P/IA who returned it to service, with certificate number.

Is AD 2008-13-12 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.