TailplateTailplate
Run a report

Airworthiness Directive 2008-22-17

recurring
Official AD 2008-22-17 · FR doc E8-25761 · 2008-11-14 · airframe

Airworthiness Directives; Boeing Model 747-100, 747-100B, 747-100B SUD, 747-200B, 747-200C, 747-200F, 747-300, 747-400, 747-400D, 747-400F, and 747SR Series Airplanes

What this AD requires

The FAA is superseding an existing airworthiness directive (AD) that applies to certain Boeing Model 747 series airplanes. That AD currently requires repetitive inspections for cracking and corrosion of all exposed surfaces of the carriage spindles (including the inner bore and aft links) of the trailing edge flaps, and additional inspection and corrective action if necessary. That AD also currently requires repetitive overhaul of the carriage spindle and aft link, which terminates the repetitive inspections. This new AD adds a repetitive inspection to detect broken parts, and revises the overhaul threshold and repetitive intervals. This AD results from analysis that showed additional inspections should be done to prevent the loss of a flap, and that the flight-hour-based interval should be revised to a flight- cycle-based interval, because the greatest loads on the spindles happen during takeoff and landing. We are issuing this AD to detect and correct failed carriage spindles or aft links of the inboard or outboard trailing edge flaps. Such failure could cause the flap to depart the airplane, reducing the flightcrew's ability to maintain the safe flight and landing of the airplane.

Repetitive inspection. Re-inspect every 2 months. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 2008-22-17 applies to

MakesBoeing
Models747-100B, 747-200B, 747-200C, 747-200F, 747-300, 747-400, 747-400D, 747-400F, 747SR

certain

Whether AD 2008-22-17 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.
Date — When the work was done.
Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.
Signature & certificate — The A&P/IA who returned it to service, with certificate number.
Is AD 2008-22-17 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.