TailplateTailplate
Run a report

Airworthiness Directive E8-25500

recurring
AD E8-25500 · 2008-10-31 · airframe

Airworthiness Directives; Cessna Aircraft Company (Type Certificate Previously Held by Columbia Aircraft Manufacturing) Models LC40-550FG, LC41-550FG, and LC42-550FG Airplanes

What this AD requires

We are adopting a new airworthiness directive (AD) to revise AD 2007-07-06, which applies to certain Cessna Aircraft Company (type certificate previously held by Columbia Aircraft Manufacturing) (Cessna) Models LC40-550FG, LC41-550FG, and LC42-550FG airplanes. AD 2007-07-06 currently requires the following: Adding information to the limitations section of the airplane flight manual (AFM); repetitively inspecting the aileron and the elevator linear bearings and control rods for foreign object debris, scarring, or damage; and taking all necessary corrective actions. Since we issued AD 2007-07-06, Cessna has issued a new service bulletin that contains procedures for installing an access panel to facilitate the required inspections. Consequently, this AD retains the actions currently required in AD 2007-07-06; allows installing access panels; and changes the serial number applicability. We are issuing this AD to prevent jamming in the aileron and elevator control systems, which could result in failure. This failure could lead to loss of control.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD E8-25500 applies to

Applicability depends on the aircraft’s type certificate — check it against the specific tail.

Whether AD E8-25500 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.
Date — When the work was done.
Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.
Signature & certificate — The A&P/IA who returned it to service, with certificate number.
Is AD E8-25500 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.