Airworthiness Directive 2008-16-17
one-timeAirworthiness Directives; PZL Swidnik S. A. Model W-3A Helicopters
What this AD requires
We are adopting a new airworthiness directive (AD) for the PZL Swidnik S. A. (PZL) Model W-3A helicopters. This AD results from mandatory continuing airworthiness information (MCAI) issued by the European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community. The MCAI states: "In PZL W-3A helicopter S/N 37.07.05, and previously also in the PZL W-3AS model helicopters, leakage was found in the pipe 37.59.006.00.00 installed in the pressure line of hydraulic system 2, in the part between the hydraulic block and the ground hydraulic unit panel. The hydraulic system in the part between hydraulic blocks and the ground hydraulic unit panel is used only during periodical inspections, for the performance of which it is required to use the hydraulic power unit. This condition, if not corrected, could result in a fire hazard." The actions specified in this AD are intended to prevent this unsafe condition.
Which aircraft AD 2008-16-17 applies to
Applies to all W-3A helicopters, all serial numbers, certificated in any category; not gated on a specific part or serial number.
Whether AD 2008-16-17 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.