Airworthiness Directive E7-2972
one-timeAirworthiness Directives; Bombardier Model DHC-8-102, -103, and -106 Airplanes; and Model DHC-8-200 and DHC-8-300 Series Airplanes
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier Model DHC-8-100 (as described above), DHC-8-200, and DHC-8-300 series airplanes. This AD requires doing a one-time inspection for damage of the electrical cable harness assembly located on the left and right wing root-to-fuselage aft seal, and repair if necessary; and reworking the fuselage aft seal assembly (left and right) to create a clearance between the electrical cable assemblies and the edge of the fairing panel. This AD results from a report that an airplane encountered an uncommanded propeller feathering during climb, which resulted in an emergency landing. We are issuing this AD to prevent chafing or grounding of the wiring against the aft seal assemblies, which, if not corrected, could interrupt the operation of various systems, including the propeller feather control, alternating current (AC) electrical power, and standby hydraulic power, and result in reduced controllability of the airplane.
Which aircraft AD E7-2972 applies to
Whether AD E7-2972 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.