TailplateTailplate
Run a report

Airworthiness Directive 2007-26-12

recurring
Official AD 2007-26-12 · FR doc E7-25395 · 2008-01-03 · airframe

Airworthiness Directives; Robinson Helicopter Company Models R22, R22 Alpha, R22 Beta, R22 Mariner, R44 and R44 II Helicopters

What this AD requires

This amendment adopts a new airworthiness directive (AD) for the specified Robinson Helicopter Company (Robinson) helicopters. This action requires a one-time visual inspection for skin separation along the leading edge of blade skin aft of the skin-to-spar bond line on the lower surface of each blade and in the tip cap area. This action also requires a "tap test" for detecting a separation or void in both bonded areas. This action also requires repainting any exposed area of the blades. If any separation or void is detected, replacing the blade before further flight is required. Thereafter, before each flight, this AD also requires checking for any exposed (bare metal) along the skin-to-spar bond line on the lower surface of each blade near the tip. If any bare metal is found, a mechanic must inspect the area. This amendment is prompted by 11 reports of blade debond, some occurring in flight causing the pilot to feel excessive vibrations and land, and some found during routine maintenance. The actions specified in this AD are intended to detect blade skin debond and to prevent blade failure and subsequent loss of control of the helicopter.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 2007-26-12 applies to

Applicability depends on the aircraft’s type certificate — check it against the specific tail.

Whether AD 2007-26-12 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.
Date — When the work was done.
Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.
Signature & certificate — The A&P/IA who returned it to service, with certificate number.
Is AD 2007-26-12 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.