Airworthiness Directive E7-14043

one-time
AD E7-14043 · 2007-07-24 · airframe

Airworthiness Directives; McDonnell Douglas Model DC-10-10 and DC-10-10F Airplanes, Model DC-10-15 Airplanes, Model DC-10-30 and DC-10-30F (KC-10A and KDC-10) Airplanes, Model DC-10-40 and DC-10-40F Airplanes, Model MD-10-10F and MD-10-30F Airplanes, and Model MD-11 and MD-11F Airplanes

What this AD requires

The FAA is adopting a new airworthiness directive (AD) for all transport category airplanes identified above. This AD requires an inspection to determine if a certain fuel pump housing electrical connector is installed. This AD also requires a revision to the FAA- approved airplane flight manual (AFM) to advise the flightcrew of the appropriate procedures for disabling certain fuel pump electrical circuits following failure of a fuel pump housing electrical connector if applicable. This AD also requires the deactivation of certain fuel tanks or fuel pumps and the installation of placards if applicable. This AD allows the optional replacement of the fuel pump housing electrical connectors with new, improved parts, which would terminate the AFM revisions, deactivation of certain fuel tanks and fuel pumps, and placard installation. This AD results from a report of two failures of the fuel pump housing electrical connector. We are issuing this AD to prevent continued arcing following a short circuit of the fuel pump housing electrical connector, which could damage the conduit that protects the power lead inside the fuel tank; this condition could create an ignition source inside the fuel tank, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.

Which aircraft AD E7-14043 applies to

ModelsDC-10-10F, DC-10-15, DC-10-30, DC-10-30F, DC-10-40, DC-10-40F, MD-10-10F, MD-10-30F, MD-11, MD-11F

certain

Whether AD E7-14043 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of complianceThe specific action taken (inspected, replaced, modified) and to what revision.
DateWhen the work was done.
Aircraft timeTotal time in service / tach at compliance — how recurring next-due is computed.
Signature & certificateThe A&P/IA who returned it to service, with certificate number.
Is AD E7-14043 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.