Airworthiness Directive 2007-13-11

one-time
Official AD 2007-13-11 · FR doc E7-11933 · 2007-06-22 · airframe

Airworthiness Directives; Eclipse Aviation Corporation Model EA500 Airplanes

What this AD requires

The FAA is adopting a new airworthiness directive (AD) for all Eclipse Aviation Corporation (Eclipse) Model EA500 airplanes. This AD requires you to incorporate information into the Limitations section of the airplane flight manual (AFM) that will require operation only in day visual flight rules (VFR), allow only a VFR flight plan, and maintain operation with two pilots. This AD is being issued because of three instances of loss of primary airspeed indication due to freezing condensation within the pitot system. The loss of air pressure in the pitot system could cause the stall warning to become unreliable and the stick pusher, overspeed warning, and autopilot to not function. The concern is heightened by the aerodynamic characteristics of the Eclipse Model EA500 airplane, which relies on the stall warning and the stick pusher to alert the pilot prior to the loss of aircraft control. The standby airspeed is reliable and not affected by this failure mode. A temporary AFM revision prohibits operation in instrument meteorological conditions (IMC), requires two pilots, and limits the airspeed and altitude envelope if the event occurs in flight. The AFM limitations and FAA operational rules allow Model EA500 flight crews to file an instrument flight rule (IFR) flight plan even though the airplane is not approved for flight in IMC. This potentially causes an undue workload burden and confusion when the pilot has to refuse any instructions that take them into IMC. We are issuing this AD to prevent an unsafe condition when Air Traffic Control's (ATC's) ability to maintain traffic separation is compromised because an airplane on an IFR flight plan cannot accept a flight plan into IMC.

Which aircraft AD 2007-13-11 applies to

MakesEclipse Aviation Corporation
ModelsEA500
Serial-conditional — narrows to serials 000001–?.

Whether AD 2007-13-11 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of complianceThe specific action taken (inspected, replaced, modified) and to what revision.
DateWhen the work was done.
Aircraft timeTotal time in service / tach at compliance — how recurring next-due is computed.
Signature & certificateThe A&P/IA who returned it to service, with certificate number.
Is AD 2007-13-11 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.