Airworthiness Directive E7-10982

recurring
AD E7-10982 · 2007-06-11 · airframe

Airworthiness Directives; Boeing Model 747-100, 747-100B, 747-100B SUD, 747-200B, 747-200C, 747-300, 747-400, 747-400D, 747SR, and 747SP Series Airplanes

What this AD requires

The FAA is superseding an existing airworthiness directive (AD), which applies to certain Boeing Model 747 airplanes. That AD currently requires repetitive inspections to detect cracks and/or corrosion of the girt bar support fitting at certain main entry doors (MED), and repair or replacement of the support fitting. The existing AD also provides for various terminating actions for the repetitive inspections. This new AD requires the following additional actions: An inspection, for certain airplanes, for correct installation of square and conical washers in the girt bar support fitting; an inspection, for certain other airplanes, to determine if the washers are installed; and related investigative and corrective action if necessary. This AD results from a report that the square and conical washers may be installed incorrectly in the girt bar support fitting on airplanes on which the support fitting was repaired or replaced in accordance with the requirements of the existing AD. We are issuing this AD to detect and correct corrosion of the girt bar support fitting, which could result in separation of the escape slide from the lower door sill during deployment, and subsequently prevent proper operation of the escape slides at the main entry doors during an emergency. We are also issuing this AD to detect and correct incorrect installation of the square and conical washers in the girt bar support fitting, which could result in failure of the escape slide when deployed.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD E7-10982 applies to

MakesBoeing
Models747-100B, 747-200B, 747-200C, 747-300, 747-400, 747-400D, 747SP, 747SR

certain

Whether AD E7-10982 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of complianceThe specific action taken (inspected, replaced, modified) and to what revision.
DateWhen the work was done.
Aircraft timeTotal time in service / tach at compliance — how recurring next-due is computed.
Signature & certificateThe A&P/IA who returned it to service, with certificate number.
Is AD E7-10982 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.