Airworthiness Directive E6-17425
one-timeAirworthiness Directives; AeroSpace Technologies of Australia Pty Ltd. Models N22B, N22S, and N24A Airplanes
What this AD requires
The FAA is adopting a new airworthiness directive (AD) to supersede AD 2003-22-13, which applies to all AeroSpace Technologies of Australia Pty Ltd. (ASTA) Models N22B and N24A airplanes. AD 2003-22-13 currently requires you to visually inspect the ailerons for damage and replace if necessary; adjust the engine power levers aural warning microswitches; set flap extension and flap down operation limitations; and fabricate and install cockpit flap extension and flap down operation restriction placards. This AD results from mandatory continuing airworthiness information (MCAI) issued by the airworthiness authority for Australia. The FAA inadvertently omitted Model N22S airplanes from the applicability of AD 2003-22-13. Therefore, this AD retains the actions exactly as required in AD 2003-22-13 and adds Model N22S airplanes to the Applicability section. We are issuing this AD to prevent failure of the aileron due to undetected pre-existing aileron damage and airplane operation outside of the approved limits. Aileron failure could lead to reduced or loss of control of the airplane.
Which aircraft AD E6-17425 applies to
applicability derived from the AD summary — confirm the model/serial from the records
Whether AD E6-17425 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.