Is AD 96-22951 a recurring Airworthiness Directive?

Yes — AD 96-22951 requires a repetitive inspection. Next-due depends on the aircraft's time in service.

Which aircraft does AD 96-22951 apply to?

AD 96-22951 applies to Fairchild — models SA226, SA227. Serial/part conditions may narrow it to specific aircraft.

Airworthiness Directive 96-22951

recurring

AD 96-22951 · 1996-09-12 · airframe

Airworthiness Directives; Fairchild Aircraft SA226 and SA227 Series Airplanes

What this AD requires

This amendment supersedes Airworthiness Directive (AD) 95-19- 07, which currently requires the following on Fairchild Aircraft SA226 and SA227 series airplanes equipped with certain main landing gear (MLG) and nose landing gear (NLG): repetitively inspecting, using ultrasonic methods, the left-hand and right-hand MLG yokes and the NLG yokes for stress corrosion cracking, and, if any cracked yokes are found that exceed certain limits, replacing either the cracked yoke, the yoke/cylinder combination, or the affected MLG or NLG assembly. This action also supersedes priority letter AD 95-19-07 R1, which was issued to incorporate revised service information. Reports of landing gear failures on the affected airplanes prompted the original AD action. This action requires the same inspections, but requires replacing any MLG and NLG assembly with any cracks instead of allowing flight until certain crack limits are exceeded. The inability to determine or predict crack growth on areas where stress corrosion occurs on primary structure with a single-load path (MLG and NLG assemblies are considered such structure) prompted this action. The actions specified by this AD are intended to prevent MLG or NLG failure caused by stress corrosion cracking in the yokes, which could result in loss of control of the airplane during landing operations.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 96-22951 applies to

MakesFairchild

ModelsSA226, SA227

equipped with

Whether AD 96-22951 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.

Date — When the work was done.

Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.

Signature & certificate — The A&P/IA who returned it to service, with certificate number.

Is AD 96-22951 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.