Airworthiness Directive 2025-20-10

recurring
Official AD 2025-20-10 · FR doc 2025-20946 · 2025-11-25 · airframe

Airworthiness Directives; Airbus Helicopters

What this AD requires

The FAA is superseding Airworthiness Directive (AD) 2021-26- 07, which applies to all Airbus Helicopters Model EC120B helicopters. AD 2021-26-07 requires performing repetitive inspections of the tail rotor (TR) hub body and, depending on the inspection results, replacing certain parts, and accomplishing further inspections. AD 2021-26-07 also requires for certain helicopters removing from service any bolt, washer, and nut installed on the TR hub body at certain life limits and replacing them with airworthy parts and accomplishing further inspections. Additionally, AD 2021-26-07 prohibits the installation of a certain part-numbered TR hub body unless certain requirements are met. Since the FAA issued AD 2021-26-07, it was determined that modifying the link of the TR hub body and splined flange by adding red paint marks is necessary to enable the detection of any loss of tightening torque. This AD retains the same repetitive inspections and corrective actions as AD 2021-26-07 and requires modification of the link of the TR hub body, which is a terminating action for the repetitive inspections. This AD also requires repetitive inspections of the red paint line added during the modification of the link of the TR hub body for alignment. The FAA is issuing this AD to address the unsafe condition on these products.

Repetitive inspection. Re-inspect every 15 hours. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 2025-20-10 applies to

MakesAirbus Helicopters
ModelsEC120B, EC120

Whether AD 2025-20-10 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of complianceThe specific action taken (inspected, replaced, modified) and to what revision.
DateWhen the work was done.
Aircraft timeTotal time in service / tach at compliance — how recurring next-due is computed.
Signature & certificateThe A&P/IA who returned it to service, with certificate number.
Is AD 2025-20-10 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.