TailplateTailplate
Run a report

Airworthiness Directive 2025-07-06

recurring
Official AD 2025-07-06 · FR doc 2025-06067 · 2025-04-10 · airframe

Airworthiness Directives; Airbus Helicopters

What this AD requires

The FAA is superseding Airworthiness Directive (AD) 2024-26- 01, which applied to all Airbus Helicopters Model H160-B helicopters. AD 2024-26-01 required measuring the axial play of the rotating scissors spherical bearings, and depending on the results, accomplishing corrective action and reporting inspection results. Since the FAA issued AD 2024-26-01, Airbus Helicopters issued revised material to extend the applicability to all rotating scissors spherical bearing serial numbers, change the initial compliance time, establish repetitive inspections, and extend the reporting requirements. This AD was prompted by a determination that the initial compliance time and reporting requirement needed to be modified and repetitive inspections for certain axial play measurements added. This AD retains the actions required in AD 2024-26-01, revises the initial compliance time, extends the definition of an affected part to all serial numbered rotating scissors spherical bearings, extends the reporting requirements, and requires repetitive inspections. This AD also prohibits installing an affected rotating scissors spherical bearing unless certain requirements are met. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 2025-07-06 applies to

MakesAirbus Helicopters
ModelsH160-B, H160

Whether AD 2025-07-06 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.
Date — When the work was done.
Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.
Signature & certificate — The A&P/IA who returned it to service, with certificate number.
Is AD 2025-07-06 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.