Airworthiness Directive 2025-03-01
recurringAirworthiness Directives; Airbus Helicopters
What this AD requires
The FAA is superseding Airworthiness Directive (AD) 2021-04- 18, which applied to Airbus Helicopters Model EC225LP helicopters. AD 2021-04-18 required repetitively inspecting the bearing in the swashplate assembly of certain main rotor (M/R) mast assemblies and, depending on the findings, replacing the M/R mast assembly. AD 2021-04- 18 also prohibited installing those M/R mast assemblies unless certain requirements were met. Since the FAA issued AD 2021-04-18, it was determined that additional M/R mast assemblies are affected by the same unsafe condition and that it is necessary to distinguish the affected part numbers between M/R mast assemblies and mast swashplate assemblies. This AD continues to require the actions specified in AD 2021-04-18 and adds additional part-numbered M/R mast assemblies and distinguishes the affected part numbers between M/R mast assemblies and mast swashplate assemblies, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD also clarifies the possible consequences that could result from the unsafe condition and clarifies a requirement. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2025-03-01 applies to
Whether AD 2025-03-01 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.