Airworthiness Directive 2024-25-07
one-timeAirworthiness Directives; General Electric Company Engines
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for certain General Electric Company (GE) Model GEnx-1B64, GEnx-1B64/P1, GEnx-1B64/P2, GEnx-1B67, GEnx-1B67/P1, GEnx-1B67/P2, GEnx-1B70, GEnx- 1B70/75/P1, GEnx-1B70/75/P2, GEnx-1B70/P1, GEnx-1B70/P2, GEnx-1B70C/P1, GEnx-1B70C/P2, GEnx-1B74/75/P1, GEnx-1B74/75/P2, GEnx-1B76/P2, GEnx- 1B76A/P2, GEnx-2B67, GEnx-2B67B, and GEnx-2B67/P engines. This AD was prompted by a manufacturer evaluation that determined a lower life limit may be necessary for certain stages 6-10 compressor rotor spools than allowed by the engine shop manual (ESM). This AD requires a one- time inspection of the stages 6-10 spools for previously accomplished blend repairs, a one-time inspection of the blend repairs on the stages 6-10 spools for compliance with the updated allowable limits, and replacement if necessary. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2024-25-07 applies to
Applies only to engines with an installed stages 6-10 compressor rotor spool having a part number and serial number listed in GE GEnx-1B Service Bulletin 72-0525 R01, dated June 10, 2024, or GE GEnx-2B Service Bulletin 72-0460 R01, dated June 10, 2024.
Whether AD 2024-25-07 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.