Airworthiness Directive 2024-20-02
one-timeAirworthiness Directives; The Boeing Company Airplanes
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 717-200 airplanes and Model DC-9-10, DC-9-20, DC-9-30, DC-9-40, and DC-9-50 series airplanes. This AD was prompted by a report of cracked and severed structure found in the aft fuselage cant bulkhead at a certain station (STA) and the vertical stabilizer rear spar installation. This AD requires a one-time inspection of the aft fuselage cant bulkhead at certain STAs and vertical stabilizer rear spar structure, and corrective actions and an inspection report if necessary. This AD also requires an inspection of that same structure if certain conditions occur during any phase of flight. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2024-20-02 applies to
Whether AD 2024-20-02 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.