Airworthiness Directive 2024-19-10
recurringAirworthiness Directives; Austro Engine GmbH Engines
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for certain Austro Engine GmbH (Austro) Model E4 and E4P engines. This AD was prompted by reports of engine failures and an investigation where cracks were discovered on the pistons. This AD requires repetitive borescope inspections (BSIs) for cracks on the pistons, and, if necessary, removal from service and replacement of the piston, and a fuel sample analysis for water contamination and, if contamination is found, replacement of the high-pressure pump (HPP), injectors, and fuel rails. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2024-19-10 applies to
Applies only to E4/E4P engines with an installed piston, part number E4A-72-400-000.
Whether AD 2024-19-10 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.