Airworthiness Directive 2024-07-06
recurringAirworthiness Directives; CFM International, S.A. Engines
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for certain CFM International, S.A. (CFM) Model LEAP-1A23, LEAP-1A24, LEAP- 1A24E1, LEAP-1A26, LEAP-1A26CJ, LEAP-1A26E1, LEAP-1A29, LEAP-1A29CJ, LEAP-1A30, LEAP-1A32, LEAP-1A33, LEAP-1A33B2, and LEAP-1A35A engines. This AD was prompted by a report of multiple aborted takeoffs and air turn-backs (ATBs) caused by high-pressure compressor (HPC) stall, which was induced by high levels of non-synchronous vibration (NSV). Additional manufacturer investigation revealed that wear on the No. 3 bearing spring finger housing can lead to high levels of NSV. This AD requires initial and repetitive calculations of the levels of NSV, inspection of the stage 2 high-pressure turbine (HPT) nozzle assembly honeycomb and HPT stator stationary seal honeycomb and, depending on the results of the calculations and inspections, replacement of certain parts. This AD also requires replacement of certain No. 3 bearing spring finger housings at a certain time. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2024-07-06 applies to
Applies only to engines with an installed No. 3 bearing spring finger housing, P/N 2629M62G01, having a serial number identified in Table 1 or Table 2 of CFM Service Bulletin (SB) LEAP-1A-72-00-0504-01A-930A-D, Issue 002, dated October 17, 2023
Whether AD 2024-07-06 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.