Airworthiness Directive 2024-06-14
one-timeAirworthiness Directives; International Aero Engines, LLC Engines
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for certain International Aero Engines, LLC (IAE) Model PW1124G1-JM, PW1127G-JM, PW1127GA-JM, PW1129G-JM, PW1130G-JM, PW1133G-JM, and PW1133GA-JM engines. This AD was prompted by a report that certain high-pressure compressor (HPC) 2nd stage rotors and HPC 4th stage rotors have potentially degraded knife-edge seals and abrasive coating of the rear wing 4th stage rotor due to having been cleaned in alkaline solution without masking the knife-edge seal coating. Operating in this condition could result in material degradation and fracture of the HPC 2nd stage rotor and HPC 4th stage rotor. This AD requires replacement of certain HPC 2nd stage rotors and HPC 4th stage rotors. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2024-06-14 applies to
Applies only to engines with an installed HPC 2nd stage rotor or HPC 4th stage rotor having a part number and serial number identified in Table 2 of Pratt & Whitney Alert Service Bulletin (ASB) PW1000G-C-72-00-0208-00A-930A-D, Issue 002, dated January 18, 2024
Whether AD 2024-06-14 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.