Is AD 2024-01-52 a recurring Airworthiness Directive?

Yes — AD 2024-01-52 requires a repetitive inspection. Next-due depends on the aircraft's time in service.

Which aircraft does AD 2024-01-52 apply to?

AD 2024-01-52 applies to Hélicoptères Guimbal — models Cabri G2. Serial/part conditions may narrow it to specific aircraft.

Airworthiness Directive 2024-01-52

recurring

Official AD 2024-01-52 · FR doc 2024-02460 · 2024-02-06 · airframe

Airworthiness Directives; Hélicoptères Guimbal Helicopters

What this AD requires

The FAA is superseding Airworthiness Directive (AD) 2023-24-51 which applied to all H[eacute]licopt[egrave]res Guimbal Model Cabri G2 helicopters. AD 2023-24-51 was prompted by reports of a crack in the pilot cyclic stick base and required repetitively inspecting certain part-numbered pilot and co-pilot cyclic stick bases and, depending on the results, corrective action. AD 2023-24-51 also prohibited installing those pilot and co-pilot cyclic stick bases unless certain requirements were met. Since the FAA issued AD 2023-24-51, more cracks in the cyclic stick bases have been reported, including a crack in a cyclic stick base that had accumulated only 700 hours time-in-service (TIS). This AD requires the same actions as AD 2023-24-51 but reduces the compliance time for performing the initial inspection. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA previously sent this AD as an emergency AD to all known U.S. owners and operators of these helicopters. The FAA is issuing this AD to address the unsafe condition on these products.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 2024-01-52 applies to

MakesHélicoptères Guimbal

ModelsCabri G2

Whether AD 2024-01-52 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.

Date — When the work was done.

Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.

Signature & certificate — The A&P/IA who returned it to service, with certificate number.

Is AD 2024-01-52 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.