Airworthiness Directive 2023-01-10
one-timeAirworthiness Directives; GE Aviation Czech s.r.o. (Type Certificate Previously Held by WALTER Engines a.s., Walter a.s., and MOTORLET a.s.) Turboprop Engines
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for certain GE Aviation Czech s.r.o. (GEAC) M601E-11, M601E-11A, M601E- 11AS, M601E-11S, and M601F model turboprop engines. This AD was prompted by the exclusion of life limits for certain compressor cases and compressor drums from the airworthiness limitations section (ALS) of the engine maintenance manual (EMM). This AD was also prompted by certain compressor cases that, following rework, were improperly re- identified and the engine logbook entries were not completed. This AD requires recalculation of the consumed life for the affected compressor cases and compressor drums and, depending on the results of the recalculation, removal and replacement of the affected compressor case or compressor drum with a part eligible for installation. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2023-01-10 applies to
Applies only to engines with an installed compressor case P/N M601-154.51 (also identified/recorded as P/N M601-154.6), or an installed compressor drum P/N M601-130.7 or M601-134.7.
Whether AD 2023-01-10 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.