Airworthiness Directive 2023-02-04
recurringAirworthiness Directives; Mooney International Corporation Airplanes
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for certain Mooney International Corporation Model M20C, M20D, M20E, M20F, and M20G airplanes. This AD was prompted by reports of the hybrid material elevator balance weight cracking. This AD requires inspecting to determine whether a certain elevator balance weight is installed. If installed, this AD requires inspecting each affected elevator balance weight for corrosion and cracking, and depending on the findings, either replacing each affected elevator balance weight with a non- hybrid (lead) elevator balance weight or repetitively inspecting each affected elevator balance weight. This AD also prohibits the installation of an affected elevator balance weight on any airplane. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2023-02-04 applies to
All serial numbers up to 680170 inclusive. Certificated in any category.
Whether AD 2023-02-04 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.