Airworthiness Directive 2022-11-05
recurringAirworthiness Directives; The Boeing Company Airplanes
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 777 airplanes. This AD was prompted by a report of the loss of the nuts at all four fastener locations common to the outboard flap inboard support rear spar attachment fittings, which affects the retention feature of the fasteners and leaves the fasteners susceptible to migrating out of the joint. This AD requires repetitive detailed inspections for discrepancies of the fasteners and shim of the wing rear spar at certain outboard flap supports; a detailed inspection for damage of the shim, flap support mechanism, and wing lower skin; installation of new fasteners and shims; and repair or replacement of damaged parts. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2022-11-05 applies to
Applicable airplanes identified in Boeing Alert Requirements Bulletin 777-57A0123 RB, dated July 8, 2021.
Whether AD 2022-11-05 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.