Airworthiness Directive 2021-18-12
recurringAirworthiness Directives; PZL Swidnik S.A. Helicopters
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for certain PZL Swidnik S.A. Model PZL W-3A helicopters. This AD was prompted by a report of fractured hoist carrying assembly bracket (bracket) bolts. This AD requires repetitively inspecting the sealing compound of certain part-numbered brackets, and depending on the results, removing the hoist or removing the hardware from service and installing new hardware. As an option to replacing the bolts, this AD allows deactivating the hoist, turning the circuit breaker panel switches to the OFF position, installing inoperative placards on the circuit breaker panel switches, and before each flight, inspecting the sealing compound. This AD also establishes a life limit for the bracket bolts, and prohibits installing an affected hoist or an affected bracket and hoist unless the actions required by this AD have been accomplished. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2021-18-12 applies to
Applies only to helicopters with hoist type 76378, or hoist carrying assembly bracket part number 39.30.205.03.01 or 39.30.213.00.00, installed.
Whether AD 2021-18-12 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.