Airworthiness Directive 2021-18-11
recurringAirworthiness Directives; Leonardo S.p.a. Helicopters
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for certain Leonardo S.p.a. Model AB139 and AW139 helicopters. This AD was prompted by a report that, during a post-flight inspection of an in- service helicopter, a tail rotor slider assembly was found fractured, and the bushing and the actuator rod in the tail rotor servo were partially damaged. This AD requires an inspection of the rail rotor tail rotor slider assembly for corrosion and signs of circumferential refinishing and, depending on the findings, replacement of the tail rotor slider assembly with a serviceable part or repetitive inspections of the tail rotor slider assembly for corrosion and signs of circumferential refinishing, as specified in a European Aviation Safety Agency (now European Union Aviation Safety Agency) (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2021-18-11 applies to
Applies only to helicopters with an affected part as identified in EASA (now EASA) AD 2018-0292, dated December 28, 2018.
Whether AD 2021-18-11 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.