Airworthiness Directive 2020-22-10
one-timeAirworthiness Directives; The Boeing Company Airplanes
What this AD requires
The FAA is superseding Airworthiness Directive (AD) 2018-14- 02, which applied to certain The Boeing Company Model 777-200, -200LR, -300, and -300ER series airplanes. AD 2018-14-02 required an inspection for foam insulation on the dripshield above the overhead panel support structure and replacement if necessary. For certain airplanes, AD 2018- 14-02 also required replacement of foam insulation on the overhead panel support structure. This AD continues to require the actions in AD 2018-14-02, and, for certain airplanes, this AD requires an inspection of the foam insulation on the overhead panel support structure, and replacement if necessary. This AD was prompted by reports that additional areas of Boeing Material Specification (BMS) 8-39 flexible urethane foam were found on the overhead panel support structure in the flight compartment. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2020-22-10 applies to
Applicability defined per Boeing Special Attention Service Bulletin 777-25-0621, Revision 2, dated February 28, 2020.
Whether AD 2020-22-10 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.