TailplateTailplate
Run a report

Airworthiness Directive 2020-16-06

recurring
Official AD 2020-16-06 · FR doc 2020-17904 · 2020-08-17 · airframe

Airworthiness Directives; Aviat Aircraft Inc.

What this AD requires

The FAA is adopting a new airworthiness directive (AD) for all Aviat Aircraft Inc. Models A-1, A-1A, A-1B, A-1C-180, and A-1C-200 airplanes. This AD requires repetitive inspections of the forward horizontal stabilizer support assembly and the rear horizontal stabilizer support tube and reporting information to the FAA. This AD was prompted by field reports of complete failure of both the forward support assembly and the rear support tube due to fatigue. The FAA is issuing this AD to address the unsafe condition on these products.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 2020-16-06 applies to

MakesAviat Aircraft Inc.
ModelsA-1, A-1A, A-1B, A-1C-180, A-1C-200, A-1C

Whether AD 2020-16-06 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.
Date — When the work was done.
Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.
Signature & certificate — The A&P/IA who returned it to service, with certificate number.
Is AD 2020-16-06 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.