Airworthiness Directive 2020-15-14
recurringAirworthiness Directives; The Boeing Company Airplanes
What this AD requires
The FAA is superseding Airworthiness Directive (AD) 2015-13- 06, which applied to certain The Boeing Company Model 747-400 and 747- 400F series airplanes. AD 2015-13-06 required repetitive inspections of the longeron extension fittings for cracking; repetitive high frequency eddy current (HFEC) inspections of any modified, repaired, or replaced longeron extension fitting for cracking; and applicable on-condition actions. This AD retains the requirements of AD 2015-13-06. This AD also requires, for certain additional airplanes, repetitive inspections of the longeron extension fittings for cracking and repair if necessary. This AD was prompted by the FAA's determination that additional airplanes are affected by the identified unsafe condition. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2020-15-14 applies to
Applies to airplanes identified in Boeing Service Bulletin 747-53A2860, Revision 3, dated November 11, 2019.
Whether AD 2020-15-14 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.