Airworthiness Directive 2020-03-15
one-timeAirworthiness Directives; Airbus SAS Airplanes
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A321-211, -212, -213, -231, and -232 airplanes. This AD was prompted by a report of erroneous positioning of affected parts on the skin of the fuselage during the pre-drill phase, which could result in unwanted drill-starts. This AD requires inspections for the presence of unwanted drill-starts on affected parts, and an inspection for cracks and corrective action if necessary, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2020-03-15 applies to
As identified in European Union Aviation Safety Agency (EASA) AD 2019-0098, dated May 3, 2019.
Whether AD 2020-03-15 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.