Airworthiness Directive 2019-13-01
one-timeAirworthiness Directives; Airbus SAS Airplanes
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A330-200, A330-300, A340-200, and A340-300 series airplanes. This AD was prompted by a report that revealed the wheel axles of the main landing gear (MLG) were machined with a certain radius and a determination that the life limit for the affected wheel axles of the MLG must be reduced. This AD requires an inspection to determine the part number and serial number of each MLG wheel axle and replacement of affected parts prior to exceeding the reduced life limits. The FAA is issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2019-13-01 applies to
Applies to all manufacturer serial numbers (MSNs) except those on which Airbus Modification 54500 has been embodied in production; A330-343 MSNs 0896, 0905, and 0913 are covered unless the actions in Airbus Service Bulletin A330-32-3273 have been embodied in service.
Whether AD 2019-13-01 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.