TailplateTailplate
Run a report

Airworthiness Directive 2019-08-07

recurring
Official AD 2019-08-07 · FR doc 2019-10653 · 2019-05-22 · airframe

Airworthiness Directives; Airbus SAS Airplanes

What this AD requires

We are superseding Airworthiness Directive (AD) 2014-20-04, which applied to all Airbus SAS Model A318 and A319 series airplanes; Airbus SAS Model A320-111, -211, -212, -214, -231, -232, and -233 airplanes; and Airbus SAS Model A321-111, -112, -131, -211, -212, -213, -231, and -232 airplanes. AD 2014-20-04 required repetitive inspections of the titanium angles between the belly fairing and the keel beam side panel, an inspection of the open holes of cracked titanium angles, and corrective action if necessary. This AD continues to require those actions, adds Model A320-216 airplanes, and requires a detailed inspection for, and replacement of, certain rivets, and corrective actions if necessary. This AD was prompted by reports of cracks at the lower riveting of the four titanium angles that connect the belly fairing to the keel beam side panels. We are issuing this AD to address the unsafe condition on these products.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 2019-08-07 applies to

MakesAirbus
ModelsA318-111, A318-112, A318-121, A318-122, A319-111, A319-112, A319-113, A319-114, A319-115, A319-131, A319-132, A319-133, A320-211, A320-212, A320-214, A320-216, A320-231, A320-232, A320-233, A321-111, A321-112, A321-131, A321-211, A321-212, A321-213, A321-231, A321-232, A318, A319, A320, A321

Airbus SAS airplanes, certificated in any category, all manufacturer serial numbers of the listed A318/A319/A320/A321 variants.

Whether AD 2019-08-07 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.
Date — When the work was done.
Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.
Signature & certificate — The A&P/IA who returned it to service, with certificate number.
Is AD 2019-08-07 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.