Is AD 2018-25-01 a recurring Airworthiness Directive?

Yes — AD 2018-25-01 requires a repetitive inspection. Next-due depends on the aircraft's time in service.

Airworthiness Directive 2018-25-01

Q: Which aircraft does AD 2018-25-01 apply to?

AD 2018-25-01 applies to Rolls Royce Plc — models Trent 1000-A, Trent 1000-C, Trent 1000-D, Trent 1000-E, Trent 1000-G, Trent 1000-H, Trent 1000. Serial/part conditions may narrow it to specific aircraft.

recurring

Official AD 2018-25-01 · FR doc 2018-26393 · 2018-12-06 · turbine engine

Airworthiness Directives; Rolls-Royce plc Turbofan Engines

What this AD requires

We are superseding airworthiness directive (AD) 2018-13-07 for all Rolls-Royce plc (RR) Trent 1000-A, Trent 1000-C, Trent 1000-D, Trent 1000-E, Trent 1000-G, and Trent 1000-H turbofan engine models. AD 2018-13-07 required initial inspections of the intermediate-pressure compressor (IPC) stage 1 rotor blades, IPC stage 2 rotor blades, and IPC shaft stage 2 dovetail posts, and removing any cracked parts from service. This AD requires initial inspections and adds repetitive inspections of the IPC stage 1 rotor blades, IPC stage 2 rotor blades, and IPC shaft stage 2 dovetail posts, and removing any cracked parts from service. This AD was prompted by the manufacturer determining the need for repetitive inspections of the IPC stage 1 rotor blades, IPC stage 2 rotor blades, and IPC shaft stage 2 dovetail posts. We are issuing this AD to address the unsafe condition on these products.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 2018-25-01 applies to

MakesRolls Royce Plc

ModelsTrent 1000-A, Trent 1000-C, Trent 1000-D, Trent 1000-E, Trent 1000-G, Trent 1000-H, Trent 1000

Whether AD 2018-25-01 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.

Date — When the work was done.

Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.

Signature & certificate — The A&P/IA who returned it to service, with certificate number.

Is AD 2018-25-01 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.