TailplateTailplate
Run a report

Airworthiness Directive 2018-20-06

recurring
Official AD 2018-20-06 · FR doc 2018-21100 · 2018-10-01 · airframe

Airworthiness Directives; Airbus SAS Airplanes

What this AD requires

We are superseding Airworthiness Directive (AD) 2016-25-03, which applied to certain Airbus Model A300 F4-600R series airplanes. AD 2016-25-03 required repetitive high frequency eddy current (HFEC) inspections of the aft lower deck cargo door (LDCD) frame forks; a one- time check of the LDCD clearances; and a one-time detailed visual inspection of hooks, eccentric bushes, and x-stops; and corrective actions if necessary. This AD requires repetitive HFEC inspections of the aft LDCD frame forks; a one-time check of the LDCD clearances; and a one-time detailed visual inspection of hooks, eccentric bushes, and x-stops; and corrective actions if necessary. This AD was prompted by a report of two adjacent frame forks that were found cracked on the aft LDCD of two airplanes during scheduled maintenance, and the introduction of frame fork reinforcement or repair procedures that, when done, allow an extension of repetitive inspection intervals. We are issuing this AD to address the unsafe condition on these products.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 2018-20-06 applies to

MakesAirbus
ModelsA300 F4-605R, A300 F4-622R, A300
Serial-conditional — narrows to serials 0805–?.

Applies only to airplanes on which Airbus modification 12046 has been embodied in production, corresponding to manufacturer serial numbers (MSNs) 0805 and above, except MSNs 0836, 0837, and 0838.

Whether AD 2018-20-06 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.
Date — When the work was done.
Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.
Signature & certificate — The A&P/IA who returned it to service, with certificate number.
Is AD 2018-20-06 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.