Airworthiness Directive 2018-15-07

one-time
Official AD 2018-15-07 · FR doc 2018-15981 · 2018-07-30 · airframe

Airworthiness Directives; Costruzioni Aeronautiche Tecnam srl Airplanes

What this AD requires

We are adopting a new airworthiness directive (AD) for certain Costruzioni Aeronautiche Tecnam srl Model P2006T airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as an incorrect part number for the rudder trim actuator is referenced in the Airworthiness Limitations section of the FAA-approved maintenance program (e.g., maintenance manual) and the life limit for that part may not be properly applied in service. We are issuing this AD to require actions to address the unsafe condition on these products.

Which aircraft AD 2018-15-07 applies to

MakesCostruzioni Aeronautiche Tecnam Srl
ModelsP2006T

Applies only to airplanes that do not incorporate design change TECNAM modification (Mod) 2006/322 at production.

Whether AD 2018-15-07 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of complianceThe specific action taken (inspected, replaced, modified) and to what revision.
DateWhen the work was done.
Aircraft timeTotal time in service / tach at compliance — how recurring next-due is computed.
Signature & certificateThe A&P/IA who returned it to service, with certificate number.
Is AD 2018-15-07 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.