Airworthiness Directive 2017-24-07
one-timeAirworthiness Directives; Airbus Airplanes
What this AD requires
We are superseding Airworthiness Directive (AD) 2014-08-01, which applied to all Airbus Model A318, A319, A320, and A321 series airplanes. AD 2014-08-01 required an inspection for part numbers of the interconnecting struts and, for affected interconnecting struts, identification of the part and serial numbers of the associated target and proximity sensors and replacement or re-identification of the flap interconnecting strut if necessary. This AD continues to require an inspection to verify the interconnecting strut part number. This AD also provides a new compliance time and an additional inspection for previously inspected airplanes. This AD was prompted by an investigation that showed that when a certain combination of target/ proximity sensor serial numbers is installed on a flap interconnecting strut, a "target FAR" signal cannot be detected when reaching the mechanical end stop of the interconnecting strut. We are issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2017-24-07 applies to
Applies to all manufacturer serial numbers.
Whether AD 2017-24-07 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.