Airworthiness Directive 2017-15-10
one-timeAirworthiness Directives; The Boeing Company Airplanes
What this AD requires
We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-9 airplanes. This AD was prompted by a determination that the shoulder bolt used on the outboard clevis of the forward support fitting of the ram air turbine (RAT) might not be long enough to allow for proper installation of the RAT; therefore, the clevis of the joint could be clamped together, resulting in reduced fatigue life and possible fracture of the clevis. This AD requires inspecting for cracking of the clevis of the forward support fitting of the RAT, installing a longer shoulder bolt, and replacing the forward support fitting if any cracking is found. We are issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2017-15-10 applies to
Applies to airplanes identified in Boeing Alert Service Bulletin B787-81205-SB290031-00, Issue 001, dated March 25, 2016.
Whether AD 2017-15-10 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.