Airworthiness Directive 2017-12-14
recurringAirworthiness Directives; The Boeing Company Airplanes
What this AD requires
We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 757-200 and -200PF series airplanes. This AD was prompted by an evaluation by the design approval holder (DAH) indicating that certain areas of the frame webs are subject to widespread fatigue damage (WFD). This AD requires inspections of the frame webs for any crack of any open coordinating holes, tooling holes, and insulation blanket attachment holes; repair if necessary; and modification of the frame webs at all open hole locations, which would terminate the repetitive inspections. We are issuing this AD to address the unsafe condition on these products.
Which aircraft AD 2017-12-14 applies to
Applies to airplanes identified in Boeing Alert Service Bulletin 757-53A0103, dated June 22, 2016. Installation of STC ST01518SE does not affect the ability to accomplish the AD's required actions; no AMOC is required for airplanes with that STC installed.
Whether AD 2017-12-14 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.