Airworthiness Directive 2014-22-09
recurringAirworthiness Directives; the Boeing Company Airplanes
What this AD requires
We are adopting a new airworthiness directive (AD) for all the Boeing Company Model 767 airplanes. This AD was prompted by a report of a rotary actuator for the trailing edge (TE) flap that had slipped relative to its mating reaction ring, which is attached to the flap support rib. This AD requires repetitive inspections for corrosion of the fixed ring gear and reaction ring splines of the rotary actuator assembly for each support position, and related investigative and corrective actions if necessary. We are issuing this AD to detect and correct flap rotary actuator gear disengagement from its mating reaction ring. This disengagement with flaps extended could cause an uncommanded roll due to flap blowback, overload, or flap departure from the airplane, which could compromise safe flight and landing of the airplane.
Which aircraft AD 2014-22-09 applies to
Applies to all Model 767-200, -300, -300F, and -400ER series airplanes. Installation of STC ST01920SE does not affect the ability to accomplish the required actions; no 'change in product' AMOC approval request is necessary for airplanes with STC ST01920SE installed.
Whether AD 2014-22-09 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.