Airworthiness Directive 2014-20-06
one-timeAirworthiness Directives; The Boeing Company Airplanes
What this AD requires
We are adopting a new airworthiness directive (AD) for all The Boeing Company Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes, and Model 777 airplanes. This AD was prompted by testing reports on certain Honeywell phase 3 display units (DUs). These DUs exhibited susceptibility to radio frequency emissions in WiFi frequency bands at radiated power levels below the levels that the displays are required to tolerate for certification of WiFi system installations. The phase 3 DUs provide primary flight information including airspeed, altitude, pitch and roll attitude, heading, and navigation information to the flightcrew. This AD requires replacing the existing phase 3 DUs with phase 1, phase 2, or phase 3A DUs, and for certain replacement DUs, installing new DU database software. We are issuing this AD to prevent loss of flight-critical information displayed to the flightcrew during a critical phase of flight, such as an approach or takeoff, which could result in loss of airplane control at an altitude insufficient for recovery, or controlled flight into terrain.
Which aircraft AD 2014-20-06 applies to
Whether AD 2014-20-06 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.