Airworthiness Directive 2014-03-11

one-time
Official AD 2014-03-11 · FR doc 2014-02961 · 2014-02-19 · airframe

Airworthiness Directives; Bell Helicopter Textron, Inc. (Bell) Helicopters

What this AD requires

We are adopting a new airworthiness directive (AD) for Bell Model 204B helicopters with a certain cable assembly installed. This AD requires inspecting the tail rotor (T/R) cable assembly for an incorrectly machined body. This AD is prompted by a report from Bell that a defective body on the cable prevents the barrel assembly from fully engaging in the body cavity. These actions are intended to prevent disengagement of the cable from the barrel, failure of the T/R pitch control, and subsequent loss of control of the helicopter.

Which aircraft AD 2014-03-11 applies to

MakesBell
Models204B, 204
Part-conditional205-001-720-001.

Applies only to helicopters with the specified cable assembly installed.

Whether AD 2014-03-11 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of complianceThe specific action taken (inspected, replaced, modified) and to what revision.
DateWhen the work was done.
Aircraft timeTotal time in service / tach at compliance — how recurring next-due is computed.
Signature & certificateThe A&P/IA who returned it to service, with certificate number.
Is AD 2014-03-11 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.