Airworthiness Directive 2013-26-04
one-timeAirworthiness Directives; The Boeing Company Airplanes
What this AD requires
We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 747-400, -400D, and -400F series airplanes. This AD was prompted by a report of water leakage into the main deck cargo wire integration unit (WIU). The water flowed from the main deck floor panels, through disbonded seams in the aft main equipment center (MEC) drip shield gutter, then onto the WIU. This AD requires cleaning the aft MEC drip shield gutter; and doing a one-time general visual inspection for disbonded seams, and repair if necessary. This AD also requires installing a fiberglass reinforcement overcoat to the underside of the bonded seams of the aft MEC drip shield gutters. We are issuing this AD to prevent water penetration into the MEC, which could result in the loss of flight critical systems.
Which aircraft AD 2013-26-04 applies to
As identified in Boeing Alert Service Bulletin 747-25A3613, dated June 22, 2012.
Whether AD 2013-26-04 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.