TailplateTailplate
Run a report

Airworthiness Directive 2013-16-09

recurring
Official AD 2013-16-09 · FR doc 2013-19023 · 2013-08-08 · airframe

Airworthiness Directives; Airbus Airplanes

What this AD requires

We are adopting a new airworthiness directive (AD) for all Airbus Model A318, A319, A320, and A321 series airplanes. This AD requires an inspection to determine airplane configuration and part numbers of the landing gear control interface unit and main landing gear (MLG) door actuators; and, for affected airplanes, repetitive inspections of the opening sequence of the MLG door actuator, and replacement of the MLG door actuator if necessary. This AD also provides optional terminating action for the repetitive inspections. This AD was prompted by a report of a MLG failing to extend during landing, and a determination that a certain configuration of landing gear control interface unit and actuators may result in masking of centralized fault display system messages that are necessary to mitigate risks associated with failure of MLG extension or down-locking. We are issuing this AD to detect and correct such a configuration, which could prevent the full extension or down-locking of the MLG, possibly resulting in MLG collapse during landing and consequent damage to the airplane and injury to occupants.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 2013-16-09 applies to

MakesAirbus
ModelsA318-111, A318-112, A318-121, A318-122, A319-111, A319-112, A319-113, A319-114, A319-115, A319-131, A319-132, A319-133, A320-111, A320-211, A320-212, A320-214, A320-231, A320-232, A320-233, A321-111, A321-112, A321-131, A321-211, A321-212, A321-213, A321-231, A321-232, A318, A319, A320, A321

Whether AD 2013-16-09 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.
Date — When the work was done.
Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.
Signature & certificate — The A&P/IA who returned it to service, with certificate number.
Is AD 2013-16-09 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.