Airworthiness Directive 2013-06589
recurringAirworthiness Directives; Cessna Aircraft Company Airplanes
What this AD requires
We are revising an existing airworthiness directive (AD) for all Cessna Aircraft Company (Cessna) Models 190, 195 (L-126A,B,C), 195A, and 195B airplanes that are equipped with certain inboard aileron hinge brackets. That AD currently requires you to repetitively inspect the affected inboard aileron hinge brackets for cracks or corrosion and replace them if cracks or corrosion is found. Replacement with aluminum brackets would terminate the need for the repetitive inspections. This new AD retains the actions of AD 2004-21-08 while requiring future compliance following a revised service bulletin that clarifies the casting numbers and part numbers to be inspected. This AD was prompted by reports of confusion between the casting number on the aileron hinge bracket and the part number (P/N) called out in the AD. We are issuing this AD to correct the unsafe condition on these products.
Which aircraft AD 2013-06589 applies to
Applicability depends on the aircraft’s type certificate — check it against the specific tail.
Whether AD 2013-06589 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.