Airworthiness Directive 2012-06-08
recurringAirworthiness Directives; Airbus Airplanes
What this AD requires
We are adopting a new airworthiness directive (AD) for certain Airbus Model A340-211, -212, -311, and -312 airplanes. This AD requires repetitive inspections for cracking at the fastener hole area just above stringer 28, of both left- and right-hand fuselage frame 39.1, and repair if necessary. This AD was prompted by a determination that certain airplanes were not included in a certain airworthiness limitation item (ALI) task (inspections for cracking of the fuselage frame 39.1) and that the inspections must be done to address the identified unsafe condition. We are issuing this AD to detect and correct cracking in the fuselage that could result in reduced structural integrity of the airplane.
Which aircraft AD 2012-06-08 applies to
Whether AD 2012-06-08 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.