TailplateTailplate
Run a report

Airworthiness Directive 2012-24-03

recurring
Official AD 2012-24-03 · FR doc 2012-28839 · 2012-12-03 · turboshaft engine

Airworthiness Directives; Turbomeca S.A. Turboshaft Engines

What this AD requires

We are superseding an existing airworthiness directive (AD) for all Turbomeca S.A. Arriel 1A, 1A1, 1A2, 1B, 1C, 1C1, 1C2, 1D, 1D1, 1E, 1E2, 1K, 1K1, 1S, and 1S1 turboshaft engines. That AD currently requires initial and repetitive visual inspections for erosion caused by dust ingestion and, if necessary, cleaning of the gas generator (module M03). This new AD requires determining the engine history; performing a one-time visual inspection of the axial compressor for erosion; performing initial and repetitive cleaning of the gas generator hollow shaft; and replacing the rear bearing if the amount of dust collected during cleaning exceeds 8 grams. This AD also includes an optional terminating action. This AD was prompted by in-service experience which has shown that dust inside the gas generator hollow shaft may be found when the axial compressor wheel has less erosion than initially assessed. We are issuing this AD to prevent an unbalance of the gas generator rotating assembly, which may lead to gas generator rear bearing failure, and uncommanded engine shutdown.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 2012-24-03 applies to

MakesTurbomeca S.A.
ModelsArriel 1A, Arriel 1A1, Arriel 1A2, Arriel 1B, Arriel 1C, Arriel 1C1, Arriel 1C2, Arriel 1D, Arriel 1D1, Arriel 1E2, Arriel 1K1, Arriel 1S, Arriel 1S1, Arriel

Applies only to engines that have not incorporated Turbomeca S.A. Modification TU360.

Whether AD 2012-24-03 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.
Date — When the work was done.
Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.
Signature & certificate — The A&P/IA who returned it to service, with certificate number.
Is AD 2012-24-03 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.