TailplateTailplate
Run a report

Airworthiness Directive 2012-1122

one-time
AD 2012-1122 · 2012-01-25 · airframe

Airworthiness Directives; Cirrus Design Corporation Airplanes

What this AD requires

We are adopting a new airworthiness directive (AD) for certain Cirrus Design Corporation (Cirrus) Model SR22T airplanes. This AD was prompted by reports of partial loss of engine power due to a dislodged rubber gasket/seal being ingested into the turbocharger. This AD requires inspection and modification of the air box flange welds and slots and installation of induction system air box seals as applicable. We are issuing this AD to correct the unsafe condition on these products.

Which aircraft AD 2012-1122 applies to

MakesCirrus Design Corporation

Whether AD 2012-1122 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.
Date — When the work was done.
Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.
Signature & certificate — The A&P/IA who returned it to service, with certificate number.
Is AD 2012-1122 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.