Airworthiness Directive 2011-09-05
one-timeAirworthiness Directives; The Boeing Company Model 777-200, -300, and -300ER Series Airplanes
What this AD requires
We are adopting a new airworthiness directive (AD) for the products listed above. This AD requires installing an auto shutoff feature for the center override/jettison fuel pumps, and installing power control circuitry for the center override/jettison and main jettison fuel pumps. This AD also requires installing new software in the electrical load management system (ELMS) electronics units in certain power management panels; installing airplane information management system 2 (AIMS-2) software in the AIMS-2 hardware; and making certain wiring changes. This AD was prompted by results from fuel system reviews conducted by the manufacturer. We are issuing this AD to prevent potential ignition sources inside fuel tanks, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.
Which aircraft AD 2011-09-05 applies to
Applies to airplanes identified in Boeing Service Bulletin 777-28A0047, Revision 5, dated September 20, 2010.
Whether AD 2011-09-05 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.