Airworthiness Directive 2010-32993
recurringAirworthiness Directives; The Boeing Company Model MD-90-30 Airplanes
What this AD requires
We are adopting a new airworthiness directive (AD) for the products listed above. This AD requires repetitive high frequency eddy current inspections for cracking on the hinge bearing lugs of the left and right sides of the center section ribs of the horizontal stabilizer, and related investigative and corrective actions if necessary. This AD was prompted by reports of cracks found on either the left or right (or in one case, both) sides of the center section ribs of the horizontal stabilizer. We are issuing this AD to detect and correct cracking in the hinge bearing lugs of the center section of the left and right ribs, which could result in failure of the hinge bearing lugs and consequent inability of the horizontal stabilizer to sustain the required loads.
Which aircraft AD 2010-32993 applies to
Whether AD 2010-32993 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.